PLL test

April 4, 2009 on 12:15

Conclusions:

Based on measurements obtained lower loop capture range - 35 kHz. The upper range could not be determined. Loop bandwidth can be increased capture of expanding bandwidth loop filter. However, this leads to a reduction of resistance to interference. Once submitted, the characteristics were obtained keeping the scope of the loop. It ranged from 5 kHz to 150 kHz. The slope characteristics kVCO = 0022 V / kHz - is the voltage conversion ratio - the frequency generator. The test loop was not possible to verify the ability to synchronize the harmonic frequencies. Free vibration frequency VCO was about 36 kHz.

Download report

Modeling and analysis of broadband amplifiers and selective
The change in the band the greatest impact (in addition to C1 and C3) is ...

Examination of serial inverters
1st The study of the natural stopping the inverter thyristors. The study was conducted in each z. ..

ACTIVE FILTER FOR SUBWOOFER
System will work with any power amplifier is not necessarily a good ...

The test three-phase rectifier trójpulsowego receiver RLE
1st Study rectifier with resistive receiver. The study was conducted with different values of load ....

Broadband HF radio circuit "
1st INTRODUCTORY NOTE Broadband high-frequency radio circuit is the foundation of today's complex ...

Categories: Electronic Report | Views [327]

Search this site



No comments.

Leave a comment